Cement block machine is a heavy-duty production equipment. Relatively speaking, the price is high. When using it to create value, you must also consider how to maintain and maintain your own equipment. When using it, you must pay attention to the rules of use to avoid unnecessary troubles. Today, Fujian Quanzhou HGMA Machinery will tell you how to maintain and maintain your cement brick machine.

1. Always keep the cement brick machine clean, remove waste and oil stains on the cement brick machine, and scrub the appearance of the machine. When the cement brick machine is running, all protective covers and floor covers must be installed. When the machine needs to be sealed up for a long time, all parts should be protected against corrosion, and checked every three months, scrubbed with gasoline, and repainted with oil.

2. Check the grounding wire of the electrical part to avoid leakage, short circuit, etc. The cement brick machine should be inspected for an intermediate repair two months after it is put into production, and an overhaul inspected once every 10 months. Pay more attention to maintenance and maintenance when using equipment, so as to reduce maintenance and produce more qualified products.

3. When the brick is produced, the brick surface is loose, the brick body is broken, or the upper mold is lifted up with the lower mold when the brick is removed, because the pressure of the upper pressure head is too low. If there is a bulge in the middle of the brick during the production of bricks, the reason is that the pressure of the upper pressure head cylinder is too high, or the vibrating time is too short, and the upper mold cannot be pressed in place. The oil pump motor was stopped or rotated hard, causing the motor to burn out, because the main pressure regulating valve of the equipment was over-regulated