1. When the fully automatic cement brick machine is tested for the first time, the operator must use a manual pallet to perform the filtering process. And it is required that the length of the pallet and its thickness error are strictly kept within plus or minus 2mm, so as to achieve the purpose of preventing the board from jamming and avoid damaging the board feeder.

 2. The hydraulic system of the fully automatic cement brick machine equipment must be adjusted to the rated pressure requirements, and the oil filter network needs to be cleaned on schedule, the oil is filtered at least once a year, and the hydraulic system is regularly checked regularly to achieve this. The safety guarantee of the components and the life of the product have been greatly extended. 

3. Check the power supply of the automatic cement brick machine equipment, including checking whether the grounding wire of the electrical part of the machine is properly connected, so as to avoid leakage, short-circuit and other phenomena causing unsafe problems. 

4. The bottom plate of the feed hopper must be kept consistent with the plane of the mold, and should be inspected and adjusted after a certain period of use. After the feed hopper is returned, the remaining material can be scraped back, and it can also reach For the purpose of cleaning the sticky material on the surface of the indenter, the upper and lower scrapers must be adjusted in this process. If excessive wear occurs, they should be disassembled and replaced in time. 

5. Check whether the part of the brick connecting machine is clean and non-polluting. If there are any pieces of material that are stuck together, they must be removed before they can be sent to the bottom plate library of the forming machine. And the time of vibration pressure should be strictly controlled. When necessary, the operator can control the amount of material released. It is required to pay attention to whether each process is normal and whether the screws are loose. If there is an unexpected situation, it needs to be shut down in time. And make adjustments.